This is not a substitute for reading the manualġ. Quick Start Guide Short form programming sheet for a monitored system Programming covers NX4, NX8, NX12, NX16, R8, R12, R128 versions of the alarm panel. This page is dedicated for all DAS NetworX and Hills Reliance alarm panels.

Programming The Hills Reliance Control Panel.

Assigning User Code Authority Levels – Function.

Setting The LED Code Pad Number And Area Options.

Hills Reliance 8 / NX8 (R8) Terminal Descriptions.

Hills Reliance 8 / NX8 (R8) Wiring Diagram.

Hills Reliance 12 / NX12 Terminal Descriptions.

Hills Reliance 12 / NX12 Wiring Diagram.

Warning: Total standby current drawn from SMOKE +, KP POS and AUX PWR +, must not exceed 700 mA with 16 VAC 3 Amp Plug Pack or 400 mA with 16 VAC 1.5 Amp Plug Pack.

Hills Reliance 128 Terminal Descriptions.

Problem Solving Hills Reliance and DAS NX Alarm Panels.

What resistors do DAS NX / Hills Reliance Alarm Panels use?.

Common Tasks when using DAS NX / Hills Reliance alarm panels.

Short form programming sheet for a monitored system.

Anyone with any idea on my next step, it would be greatly appreciated. I am totally open to suggestions on how to troubleshoot this. Even doing a factory reset does not remove this. I am using an external transformer rated at 12V 500ma.Ħ) I do have an Eyez-On EVL-4 installed, but this should not have an effect.ħ) I did notice there is a option for TC SERVER INFO and it looks to be set up for Alarm Net communication somehow. Note I am not powering the Tuxedo from the panel.

MCU Firmware 1.11Ģ) Vista 20P panel purchased new, running firmware 10.23ģ) Enabled all four AUI devices via *189 programming option for partition 1Ĥ) Enabled keypads via programming options *190 thru *193ĥ) Verified wiring and power. This is the scenario:ġ) Tuxedo Touch purchased used, running software version TUXW_V5.1.13.0. I'm begging to think it may be the firmware or even the Tuxedo Touch itself as the problem. I can not get past ECP errors no matter what address 1,2,5 or 6 that are available.

I have a used Tuxedo Touch WiFi model I am trying to install on a Vista 20P panel. All I needed to do was jumper the (-) NEG wire from the power supply to the GND on the panel. FIXED: So, if you read the instructions carefully, you usually find a solution.

Networx nx8 how to clear smoke detector